D7
DOOR ACTIVATOR
FOR AUTOMATIC DOORS

Swinging · Sliding · Revolving

Compact and unobtrusive metal enclosure
Adjustable patterns (wide or narrow available)
Normal and short range adjustment
Red LED activation indicator
12 to 24 VAC/DC power requirements
Four incremental frequencies available
Variable time delay (VTD) option available
Field-proven by over 150,000 units

The model D7 door activator is a motion sensor designed to trigger the operation of all types of automatic doors. An installer's dream, the D7 is unmatched in ease of mounting and pattern setup. It is versatile and can be used in both directions of travel on sliding or revolving doors, or on the approach side of a swinging door. It is housed in a compact, rugged metal enclosure and mounts easily to the header over the center of the entranceway.

Key Benefits

	Motion caused by a person moving in the D7's pattern is immediately detected by the sensor. It accomplishes this through a low power yet broad microwave beam that is volumetric throughout its pattern; any motion will send a shifted signal back to the detector, causing a relay within the unit to trip. This relay contacts the door control and initiates the open cycle of the door.
	The D7 is much more cost-effective to install and maintain than floor mat switches simply because it is mounted overhead. It is not affected by freezing water, salt, or other chemicals.
	The D7 can use one of two antennas, resulting in two different pattern sizes (see reverse side for patterns). Both patterns are fully adjustable and can be reduced in size proportionally to the required dimensions.
	Reliability is the hallmark of the D7 door activator. Quality construction and solid-state circuitry make it so. Its small size and trim appearance make the D7 ideal for any automatic entranceway.

Specifications

ACTIVATING DEVICES

1.1 Microwave motion detector Model D7 manufactured by Microwave Sensors Inc. shall be used.

1.2 A single slide door detection system shall include two D7 actuators and two DB-11 Door Beams per ANSI stds.

1.3 A single swing door detection system shall include one D7, one D-14-2 one RL-3 and one DB11-S Door Beam on guard rails.

1.4 The D7 shall be installed on the door header and in a centered position to the clear opening (can be concealed within ceiling).

1.5 Movement detected within the unit's microwave field shall be transmitted to the electronic controls for door actuation.

1.6 The microwave pattern shall not be affected by temperature or humidity changes.

1.7 The detection pattern shall be adjustable without removing the enclosure cover.

1.8 One red LED shall indicate an active relay status.

1.9 The two door beams (DB-11) installed in the door jambs 21" & 36" above the floor shall prevent the door from closing until traffic has cleared.

TECHNICAL DATA